FEATURES

• Engineering units multiplier (.0001 to 9.9999)
• Analog output option
• Two separate displays for rate/total and a third for ratio/ difference (optional)
• Two relay alarm outputs
• High-speed counter: 10 KHz per channel
• Serial interface option, RS232 or RS485

Series 6100C
The new 6100C is a versatile dual channel indicator with a high-speed microprocessor to perform math functions on the two inputs. The unit will display a rate, ratio, totalize, or show a linear or angular position with inputs from incremental or absolute encoders. The unit is available with a .56" six digit LED display with thumbwheels for setting the limits, or the .56" LED display and two 6 digit .3" LED displays. The two smaller displays will show the limits or two rate inputs with the main display showing the ratio of the two inputs. When used as a readout for an absolute encoder the unit can be programmed to accept BCD, natural binary, grey code, or excess three BCD code. An analog output option is available so the unit can be used for control function or to interface to an A/D input card on a computer or PLC.

SPECIFICATIONS
Accuracy:
±1 count of LSD

Input Count Rate:
1 Hz to 10KHz

Gate Time Resolutions:
1 to 9 seconds in one second steps Programmable by front panel switches or serial interface

Engineering Units Multiplier:
.001 to 9.9999, Programmable by front panel switches or serial interface.

Sensitivity:
Sine wave/pulse input only
Minimum signal 150mVRMS
Maximum signal 115VAC without damage to circuitry.
Input impedance 100Kohm. Threshold adjustable from the front panel with a small screw driver.

Display:
Six .56" high-efficiency red LED's with decimal points Decimal points are programmable with front panel switches LED's to indicate status of limits
Optional: In addition to the six .56" LED's, two sets of six .3" LED's can be added to display two rates

Front Panel Controls:
4 push buttons and 6 indicator LED's.
Optional: Six thumbwheel switches for setting limits.

Remote Control Input:
4 remote inputs duplicate pushbutton functions

Outputs:
Two from "C" relays for alarm outputs. Contact rating .25A at 28V.

Optional: RS232/RS485 interface. Baud rate - 75, 150, 300, 600, 1200, 2400, 4800, 9600-8 data bits, 1 stop bit, no parity. Suitable with printer output, programmable print times of 2 times/sec. to once every hour in one second steps.

Optional: TTL compatible parallel BCD or natural binary.

Analog output:
(Optional) 0-10VDC @ 1mA. Resolution of D/A is 16 bits (65000 counts) and the update rate of the D/A is 10 times per second. Zero point and 10V points are programmable from the front panel. The number for the 10V point may be a positive or negative number.

Input Power:
115VAC ±10%, 50 - 400Hz, 5 watts maximum Options 230VAC ±10%, 50 - 400Hz 5 watts maximum DC Power 5 VDC and 10 - 30 VDC, 600mA maximum

Operating temperature:
-20° to +60° Celsius.

Power Loss Protection:
Solid state memory stores all setup parameters and limits during power loss.

I/O Method:
Three prong power entry module (IEC) 25 pin "D" connectors for all I/O except serial interface 6 pin phone jack for RS232 or RS485 serial interface